FABRIC: elastic jersey.
YOU WILL ALSO NEED: one small
button; bias binding; elastic lace; hook-and-eye tape.
IF THE PATTERNS HAVE DOUBLE
CONTOUR, THE SEAM ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR,
THE SEAM ALLOWANCE IS NOT PROVIDED.
ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150
cm) to find out how much material you need (do not forget about double and
symmetric pieces).
WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE
MATCHING!
ADVICE:
to prevent seam from stiffing, sew pieces with special (zigzag) stitch.
To
prevent hem from stiffing neaten it with overlocker
and then stitch using double
needle. Do the same for all edges must stay elastic.
The above is not for industrial
manufacturing.
CUTTING:
Fabric:
2. Back – 2 pieces
4. Front – 1 folded piece
Lace:
1. Back yoke - 2 pieces
3. Front yoke – 1 folded piece
5. Crotch facing – 2 pieces
INSTRUCTIONS:
1. Stitch the back yoke central seam
leaving a fastening slit. Stitch the back centre
seam.
2. Stitch the shoulder seams of the yokes.
3.
Cut the seam allowances of the back/front top edges away. Stitch bias binding
to the wrong side of the garment, turn it round the edges to the right side and
topstitch it. Use this method to finish the neckline and armholes.
4.
Stitch the side seams. Cut the seam allowances away from the leg openings and
finish them with the bias binding tape. Cut the seam allowances away from the
outer crotch facing and finish it with the bias binding also.
6.
Press the inside leg seam allowances to the wrong side. Place the hook-and-eye
tape under them and topstitch it stitching on the right side of the garment.
7.
Make a loop on the right top edge of the slit, attach the button to the left
side.