You need: fleece,
lining, fusing, zipper.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALOWANCES: 1 cm
for all seams.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric details).
WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE
COINCIDING!
CUTTING:
Fabric:
1. Square – 25 pieces
2.
Collar – 1 piece
Lining:
1. Poncho – 1 piece
Fusing:
1. Collar – 1 piece
INSTRUCTIONS:
1. Apply the fusing
to wrong side of the collar.
2. Fold the collar
along the center wrong side out, lay the zipper between short edges with zipper
teeth inside, then overstitch. Turn the collar right side out, then press. Make
decorative stitching on collar upper edge along the zipper.
3. Stitch squares
together according to poncho general form. Press seam allowances apart.
4. Mark neckline line
on center square. Cut a hole leaving 1 cm allowance to stitch the collar in.
Tack the collar into neckline.
5. Mark neckline at
the lining. Cut a hole leaving 1 cm allowance to stitch the collar in. Lay the
garment on the lining right sides together, then overstitch the neckline
stitching in the collar. Slash rounded allowances. Overstitch the poncho along
the perimeter leaving a hole into a side to turn the poncho right side out.
Slash allowances into corners. Turn the poncho right side out, sew hole’s edges
together, then press. Make decorative stitch along edges.