You need: soft
wool (easy to drape), piping.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCES: 0 cm
for garment/sleeve hems as well as for hood edge and front edging. 1 cm for other
seams.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric details).
WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE
COINCIDING!
CUTTING:
Fabric:
1. Back part – 1
piece
2. Front part – 2
pieces
3. Sleeve – 2 pieces
4. Hood – 2 pieces
5. Waistband – 1
piece
6. Belt loop – 1
piece
INSTRUCTIONS:
1. Stitch hood middle
edge. Press the seam. Press the piping along the center. Trim seam allowances
with the piping.
2. Stitch shoulder
edges. Neaten seams and press them backward.
3. Stitch the hood
into neckline. Press seam toward the hood. Trim seam allowance with the piping.
4. Trim sleeve hems
with the piping.
5. Stitch sleeves
into open armholes.
6. Stitch sleeve
edge/side edge with one seam. Press the seam apart.
7. Trim garment hem
with the piping. Trim front edging and hood edge. Press front edging as marked,
then stitch.
8. Fold belt loop
wrong side out, then stitch. Turn the detail right side out, then press. Cut
the loop into 4 pieces. Sew belt loops to marked lines on front/back parts.
9. Fold the waistband
along the center wrong side out, overstitch it along three edges leaving 7-10
cm segment in the middle of long edge. Turn the waistband tight side out and
press it. Make decorative stitching at 0.5 cm from the contour stitching the
hole.