7082 COTTON VELVET PANTS

YOU NEED: cotton velvet; fusing; 1 zipper; 1 button.

IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM ALLOWANCE IS PROVIDED,

IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM ALLOWANCE IS NOT PROVIDED.

SEAM ALLOWANCE: 1 cm for all seams, 3 cm for hem.

ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150 cm) to find out how much material you need (do not forget about double and symmetric details).

WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!

CUTTING:

Fabric:

1. Waistband – 1 piece

2. Yoke – 2 pieces

3. Back part – 2 pieces

4. Upper front part – 2 pieces

5. Middle front part – 2 pieces

6. Lower front part – 2 pieces

7. Pocket – 2 pieces

8. Belt loop – 1 piece

9. Button catch – 1 piece

Fusing: waistband, button catch, pocket entrance allowance.

INSTRUCTIONS:

1. Apply the fusing to wrong side of waistband, button catch, pocket entrance allowance.

2. Neaten patch pocket edges: long side edge, entrance edge and lower edge. Press neatened allowances according to pattern. Topstitch pocket entrance allowance at 0.5 cm from edge.

3. Mark pocket place on front part and topstitch side/lower sides of pocket at 0.2 cm from pocket outer edge leaving pocket entrance unstitched.

4. Stitch the yoke to back part; neaten joining seam and press it towards yoke. Make decorative stitch above joining seam at 0.5 cm.

5. Stitch front part details together. Press seams towards middle part and topstitch along seam.

6. Neaten garment front/middle edges and garment hems. Stitch side seams and leg inside seams and neaten them. Press them backwards. Stitch front edge and middle edge up to closure notch. Make another stitch along crotch seam close to seam joining front seam and middle seam.

7. Press closure one-piece facing into wrong side. Stitch the zipper under closure left allowance. Stitch zipper free braid to right one-piece facing. Fold the button catch along the center and overstitch lower short edge. Topstitch closure one-piece facing on left button catch. Topstitch slit right edge catching the facing.

8. Fold belt loop along the center wrong side out, adjust edges and overstitch at 0.5-0.7 cm from edges. Then turn it right side out, place the seam at fold line or make edging of 0.1-0.2 cm width into wrong side, and press it.

9. Press the waistband along the center right side out and neaten waistband lower inner edge. Cut belt loops according to size and topstitch them on garment upper edge on marks.

10. Topstitch the waistband to garment upper edge. Overstitch waistband ends. Cut seam allowances into corners and turn the waistband right side out. Topstitch waistband lower neatened edge on joining seam and press ready waistband.

11. Press hem allowances into wrong side and topstitch.

12. Make the buttonhole into waistband right end, sew the button on left end.